Instructions Page
TAKE A CARD ROUND
1. After you open the Take A Card and remove its contents, you will need to remove the protective film from both sides of the clear window strip.
2. Place one of your business cards into the bevelled area and secure it with the window strip provided. Ensure that the square cut-out in the window strip is at the bottom so moisture can escape. You will need to slightly bend the window to properly place it within the slots as shown in figure 2.
3. Remove the protective backing from the 3M tape and place the Take A Card on your vehicle's window, door, or other location.
4. Attach the "Business Cards Here" sticker above your Take A Card. This will let your potential customers know to flip open the lid to take a business card.
Removal Instructions
The adhesive residue can be wet with a solvent then covered with a plastic film and allowed to soak for 5-15 minutes. Once the adhesive is softened, use a plastic scraper to remove the adhesive. Solvents to use include:
- 3M Citrus Base Cleaner
- MEK(Methyl-Ethyl-Ketone)
- Automotive bug and tar remover
- Other commercial adhesive removers.
Read solvents instructions carefully.
The adhesive residue can be wet with a solvent then covered with a plastic film and allowed to soak for 5-15 minutes. Once the adhesive is softened, use a plastic scraper to remove the adhesive. Solvents to use include:
- 3M Citrus Base Cleaner
- MEK(Methyl-Ethyl-Ketone)
- Automotive bug and tar remover
- Other commercial adhesive removers.
Read solvents instructions carefully.
GRAB A CARD SQUARE
